RF-4B Phantom / VMCJ-3 Airplane Model

RF-4B Phantom / VMCJ-3 Airplane ModelVMCJ 3 RF 4B Phantom airplane model. In the initial Model 98 package that was submitted to the Navy, McDonnell had included a Model 98P, which was a photographic reconnaissance version of the basic design. The Navy initially expressed no interest in the Model 98P proposal, since they were perfectly happy with the F8U 1P reconnaissance version of the Crusader. However, the F8U 1P lacked the night reconnaissance capability that was being planned in

VMCJ-3 RF-4B Phantom airplane model. In the initial Model 98 package that was submitted to the Navy, McDonnell had included a Model 98P, which was a photographic reconnaissance version of the basic design. The Navy initially expressed no interest in the Model 98P proposal, since they were perfectly happy with the F8U-1P reconnaissance version of the Crusader. However, the F8U-1P lacked the night reconnaissance capability that was being planned in early 1962 for the Air Force's RF-110A reconnaissance version of the land-based Phantom. This caused the Navy to take a second look at the Model 98P, and in February 1963 the Marine Corps agreed to acquire the first 9 of an eventual 46 RF-4Bs.

In initial proposals and in pre-contract negotiations, this aircraft had initially been referred to as F4H-1P. However, this was changed to RF-4B in September 1962 when the new unified designation scheme came into effect.

The RF-4B was quite similar to the much more numerous RF-4C of the USAF. Like the RF-4C, the RF-4B was unarmed. The fighter's radar-equipped nose was replaced with a special nose specifically designed for reconnaissance applications. This nose was 4 feet 8 7/8 inches longer than the nose of the armed F-4B. The AN/APQ-72 radar of the F-4B was replaced by the much smaller Texas Instruments AN/APQ-99 forward-looking J-band monopulse radar which was optimized for terrain avoidance and terrain-following modes, and could also be used for ground mapping. There were three separate camera bays in the nose, designated Stations 1, 2, and 3. Station 1 could carry a single forward oblique or vertical KS-87 camera, Station 2 could carry a single KA-87 low-altitude camera, and Station 3 normally carried a single KA-55A or KA-91 high-altitude panoramic camera. The much larger KS-91 or KS-127A camera could also be carried. Unlike the cameras of the Air Force's RF-4Cs, the RF-4B's cameras were fitted on rotating mounts so that the pilot could aim them at targets off the flight path.

Mahogany Wood. Scale 1/48. Wingspan 10 inches, Length 15 1/2 inches.