Star Trek Enterprise 1701 Refit Navigation/Strobe Board

Star Trek Enterprise 1701 Refit Navigation/Strobe BoardTenaControls 1001 BB Star Trek Enterprise 1701 Refit Navigation Strobe Board. Provides NAV and Strobe Lights for the Enterprise NCC 1701 A. This board simulates the Navigation and Strobe lights on the Star Trek Enterprise 1701 and 1701 A Refit. You will receive all the Navigation LEDs which are white, green and red as well as the white Strobe LEDs. This board fits nicely inside the saucer section for easy wiring to all the saucer sections, Navigation

TenaControls 1001-BB Star Trek Enterprise 1701 Refit Navigation/Strobe Board. Provides NAV and Strobe Lights for the Enterprise NCC-1701/A. This board simulates the Navigation and Strobe lights on the Star Trek Enterprise 1701 and 1701-A Refit. You will receive all the Navigation LED’s which are white, green and red as well as the white Strobe LED’s. This board fits nicely inside the saucer section for easy wiring to all the saucer sections, Navigation and Strobe LED’s. Hot glue is recommended for securing the board in place. This board can also be used in any model or application where LED’s need to be controlled at a certain interval. Navigation – 1 second On/Off. Strobes On – twice per second. The board size is extremely small (0.70 inch x 0.875 inch). Also included: Fully assembled – just connect switch, battery clip and LED’s, One (1) Battery clip for 9 volt battery, One (1) on/off switch – commercial grade, One (1) Micro JST Connector with wires, Wiring and shrink tubing, Red, Green and White LED’s, Best warranty in the business – 5 Year Warranty -volt battery holder and micro On/Off slide switch, which turns the car light board on or off, to the board for your convenience. You just need to plug the eight-wire JST connector into the mating connector on the board and connect the LED to its corresponding wire coming from the eight-wire JST connector. The magnetic reed switch allows you to toggle through all the light modes, just by using the enclosed supplied magnet. This feature allows for the car to stay intact, with no holes for a momentary switch (on plastic model cars). What’s included: One (1) fully assembled board – just connect the LED. One (1) battery clip for 12 12-volt battery and a 12-volt battery., One (1) on/off switch wired to the board., One (1) magnetic reed switch. One (1) magnet. Shrink tubing. Red, Orange and White LEDS. Miniature eight-wire JST connector. Best warranty in the business – 5 Year Warranty (for warranty claims, the buyer should contact TenaControls directly)., Made in the USA. Important: No interior or window lighting is supplied with this kit. This board will also work on 12 volt DC supply. This board can also be used in any model or application where LED’s need to be controlled at a certain interval. Model kit not included